Robert Axle Project 12mm Thru Axle for Trainer

Robert Axle Project 12mm Thru Axle for Trainer

$107.99
Quantity:

More From Robert Axle Project

Pickup available at County Cycle Usually ready in 24 hours

Robert Axle Project 12mm Thru Axle for Trainer

County Cycle

Pickup available, usually ready in 24 hours

4977 King Street
Beamsville ON L0R 1B0
Canada

+12895668855

Hours

Mon - Fri 10am-6pm / Sat 10am-5pm

Designed to adapt your thru axle equipped bike with your wheel-on trainer, such as a 1up, Blackburn, Cyclops, Kinetic, Tacx, Wahoo and many other trainers. Train, warm up and be race ready and fit for the season.

Cervelo owners with RAT thru axles: This axle will replace the RAT axle found on all of their RAT equipped bikes. In addition to this axle you will need to replace the RAT compatible derailleur hanger with Cervelo threaded hanger Part Code: DRH-WMN112. This axle combined with the replacement derailleur hanger will provide a complete threaded thru axle system.

Important: Before you order, make sure your specific trainer will accommodate the width of your modern thru-axle equipped bike. Measure your trainer at the widest setting and measure the outside width of your bike frame. The trainer axle ends will extend 15mm past your frame on each side.

Dimensions:

  • 170mm Length
  • 12mm axle
  • 1.75mm Thread Pitch

Model # TRA223

Robert Axle for Trainers replaces your stock 12 mm thru axle so you can use your bike on a trainer.

  • This axle is compatible with BKool, Blackburn, Cyclops, Kinetic, Tacx, Wahoo and many other on-wheel resistance trainers.
  • The true length of the axle shaft is 170 mm. Please note: Thru-axle lengths do not equal hub standards. An axle has to be longer than the hub to fit in the frame. A 12×142 hub does not equal a 142 mm long axle.
  • This axle has a 1.75 mm thread pitch.
  • The axle shaft and axle ends are precision CNC machined from 7075 aluminum, and hard anodized for rugged durability.
  • No special tools required. Design allows for installation or wheel removal using your standard 5mm hex wrench.
  • Designed, built and quality tested in the USA. Proven around the world